Bathroom Mold Removal in Denham Springs, LA
The ceiling over the shower has gone from a few specks to a gray cloud. The drywall behind the toilet is soft when you press it. The bottom of the vanity cabinet is dark and swollen from a supply line that has been dripping longer than anyone knew. We do bathroom mold removal in Denham Springs, Walker, Watson, and across Livingston Parish. Call and tell us which wall.
No room stays wet like a bathroom
A family of four puts a lot of steam into a small room, and most bathrooms in the slab subdivisions here have a fan that either doesn’t move enough air or vents into the attic instead of outside. Add a shower pan that seeps, a wax ring that failed, or a toilet supply line that weeps at the fitting, and the drywall and the sill plate behind the tile stay damp year-round. Grout and caulk you can scrub. Drywall, particleboard cabinets, and wet subfloor you can’t.
Why the bathroom spot keeps coming back
- Bleach lightens the surface of the drywall and wets it at the same time; the growth inside the sheet stays where it was.
- A small patch you clean every month is usually the surface of a wetter problem behind the wall or under the floor.
- A little DIY cleanup turns into a larger removal project when the vanity comes out and the wall behind it has been wet for a year.
- Repeated mold in the same corner points back to a moisture problem that never got solved.
If It Keeps Coming Back, We Answer 24/7
What the removal involves
The bathroom gets sealed at the door and put under negative pressure. Affected drywall, the vanity base if it’s swollen, and any wet subfloor come out, bagged. Tile, tub, and fixtures stay and get cleaned. Framing behind the wall is cleaned and dried until it reads dry, and we tell you what has to change — the fan, the pan, the supply line — so the new wall doesn’t end up where the old one did. EPA’s ideal indoor humidity is 30 to 50 percent, and a bathroom that vents outside is the first step toward it.
